hi,

selling above items.



FP60 increases combustion efficiency, lubricates fuel pumps and injectors, cleans the fuel system, and potentially increases mileage. It scavenges water and moisture from the fuel system as well so the resulting mix can be burned in the combustion chamber. Combustion chambers can be cleaned using FP60.

LC20 levels the TBN, reduces oxidation, provides an extra measure of lubricity, provides extra rust control, and will literally melt (soften and emulsify) carbonaceous deposits. It then places these carbonaceous deposits into the oil solution. LC20 keeps your oil in good condition and reduces oxidation so well that oil change intervals can be extended. We recommend changing oil at 10,000 miles when adding LC20 every 1,000 miles. LC20 can also be used as a cylinder preparatory storage oil (squirted into the individual cylinder) in automotive and small engines to clean carbon deposits and keep rings and cylinders from rusting during storage. 2-cycle and 4-cycle engines that have stuck rings can be unstuck with LC20.



More information regarding FP60 or LC 20, please visit http://lubecontrol.com/fuel.htm



Stocks available for FP60 per gallon @ $98, LC20 @ $36 per quart, $98 per gallon. A special 1 litre container will be given away for those who purchase gallon capacity (while stocks last).

Interest party, please email to shhub2009@gmail.com or pm to me for collection or delivery arrangement.

thanks and regards

sh

hi,

some more information of the products.

http://www.o2asis.com/lab.htm

cheers

upz!

upz!

Refresh!!!

upz!

upz!

hi,

selling above items.



FP60

FP60 increases combustion efficiency, lubricates fuel pumps and injectors, cleans the fuel system, and potentially increases mileage. It scavenges water and moisture from the fuel system as well so the resulting mix can be burned in the combustion chamber. Combustion chambers can be cleaned using FP60.

What will FP60 do for my car ?

FP60 is special blend of chemicals designed to clean your vehicle’s fuel system and increase the potential energy in the fuel mixture. This in turn will potentially increase fuel mileage and lengthen vehicle running time. This product will not only clean but protect a vehicle’s fuel system by leaving a thin protective coat of oil over vital fuel system parts including fuel pump, gas tank and fuel injectors. FP60 also acts as a fuel stabilizer by dissolving carbon deposits and lowering the fuel mixture freezing points in both gas and diesel fuels. This product has also been proven to decrease both carbon monoxide and nitrous oxide emissions up to 30% which will reduce pollution.


The recommended dosage is located on each bottle of product: 1oz. for every 5 gallons of gas or diesel fuel added. Shake well before every application.



LC20

LC20 levels the TBN, reduces oxidation, provides an extra measure of lubricity, provides extra rust control, and will literally melt (soften and emulsify) carbonaceous deposits. It then places these carbonaceous deposits into the oil solution. LC20 keeps your oil in good condition and reduces oxidation so well that oil change intervals can be extended. We recommend changing oil at 10,000 miles when adding LC20 every 1,000 miles. LC20 can also be used as a cylinder preparatory storage oil (squirted into the individual cylinder) in automotive and small engines to clean carbon deposits and keep rings and cylinders from rusting during storage. 2-cycle and 4-cycle engines that have stuck rings can be unstuck with LC20.

LC20 works with all forms of motor oils, including synthetic, and has a variety of uses such as end of season storage, removing carbon and varnish, and pre-conditioning the rings before startup. This product will also enhance hydraulic systems, as proven in a report preformed by Dyson’s Analysis.

How will LC20 prolong your oil's life ?

LC20 is a special blend of chemicals that is designed to clean and protect your engines oil, power steering, and automatic transmission systems. This product will break down and dissolve carbon deposits that can be harmful to your engine and it will penetrate into even the smallest spaces in your engine to clean and lubricate. LC20 works so well at keeping your oil clean that we recommend you change your oil every 10,000 miles instead of every 3,000 miles saving both time and money.

LC20 works with all forms of motor oils, including synthetic, and has a variety of uses such as end of season storage, removing combustion, and pre-conditioning the rings before startup. This product will also enhance hydraulic systems, as proven in a report preformed by Dyson’s Analysis.

The recommended treatment rate of LC for engine lubes in 4-cycle
gasoline or Diesel engines is 1 0z./Quart for the initial dose, and 1
oz. every 1,000 miles or 1,610 km. Do not overfill crankcase.



Stocks available for FP60 per gallon @ $98 (UP $118.00), LC20 @ $36 per quart, $98 per gallon. A special 1 litre container will be given away for those who purchase gallon capacity (while stocks last).

Interest party, please email to shhub2009@gmail.com or pm to me for collection or delivery arrangement.

thanks and regards

sh2009

Refresh!

Refresh!

Refresh!

Upz!

hi,

Promoting the items below,



FP60

FP60 increases combustion efficiency, lubricates fuel pumps and injectors, cleans the fuel system, and potentially increases mileage. It scavenges water and moisture from the fuel system as well so the resulting mix can be burned in the combustion chamber. Combustion chambers can be cleaned using FP60.

What will FP60 do for my car ?

FP60 is special blend of chemicals designed to clean your vehicle’s fuel system and increase the potential energy in the fuel mixture. This in turn will potentially increase fuel mileage and lengthen vehicle running time. This product will not only clean but protect a vehicle’s fuel system by leaving a thin protective coat of oil over vital fuel system parts including fuel pump, gas tank and fuel injectors. FP60 also acts as a fuel stabilizer by dissolving carbon deposits and lowering the fuel mixture freezing points in both gas and diesel fuels. This product has also been proven to decrease both carbon monoxide and nitrous oxide emissions up to 30% which will reduce pollution.


The recommended dosage is located on each bottle of product: 1oz. for every 5 gallons of gas or diesel fuel added. Shake well before every application.



LC20

LC20 levels the TBN, reduces oxidation, provides an extra measure of lubricity, provides extra rust control, and will literally melt (soften and emulsify) carbonaceous deposits. It then places these carbonaceous deposits into the oil solution. LC20 keeps your oil in good condition and reduces oxidation so well that oil change intervals can be extended. We recommend changing oil at 10,000 miles when adding LC20 every 1,000 miles. LC20 can also be used as a cylinder preparatory storage oil (squirted into the individual cylinder) in automotive and small engines to clean carbon deposits and keep rings and cylinders from rusting during storage. 2-cycle and 4-cycle engines that have stuck rings can be unstuck with LC20.

LC20 works with all forms of motor oils, including synthetic, and has a variety of uses such as end of season storage, removing carbon and varnish, and pre-conditioning the rings before startup. This product will also enhance hydraulic systems, as proven in a report preformed by Dyson’s Analysis.

How will LC20 prolong your oil's life ?

LC20 is a special blend of chemicals that is designed to clean and protect your engines oil, power steering, and automatic transmission systems. This product will break down and dissolve carbon deposits that can be harmful to your engine and it will penetrate into even the smallest spaces in your engine to clean and lubricate. LC20 works so well at keeping your oil clean that we recommend you change your oil every 10,000 miles instead of every 3,000 miles saving both time and money.

LC20 works with all forms of motor oils, including synthetic, and has a variety of uses such as end of season storage, removing combustion, and pre-conditioning the rings before startup. This product will also enhance hydraulic systems, as proven in a report preformed by Dyson’s Analysis.

The recommended treatment rate of LC for engine lubes in 4-cycle
gasoline or Diesel engines is 1 0z./Quart for the initial dose, and 1
oz. every 1,000 miles or 1,610 km. Do not overfill crankcase.



Stocks available for FP60 per gallon @ $98 (UP $118.00), LC20 @ $36 per quart, $98 per gallon. A special 1 litre container will be given away for those who purchase gallon capacity (while stocks last).

Interest party, please email to shhub2009@gmail.com or pm to me for collection or delivery arrangement.

thanks and regards

sh2009

refresh!

upz!